Removing the motherboard should be done in the reverse order.
Proper procedure involves when inserting the motherboard is to mount and secure the four heatsink bolts then secure the motherboard to the tray mounting screws/bolts. NOTE: However doing it this way care must be taken when inserting or removing the motherboard as it is more likely to flex when doing so due to the state of the x-clamp. Secure the motherboard to the tray using bolts/screws. Position the x-clamp in-between the four standoffs.ħ. Mount the standoffs to the bottom tray using the x-clamp holes.Ĥ. Create threaded standoffs 9.5mm (H) 4.8mm (W) and thread for 3mm.ģ. Recommend buying a 2nd one to use here.Ģ. Grind the four curls off of each leg end. The x-clamp hardware can still be used but require a bit of extra effort.ĬHOICE 1 - Using Modified X-Clamp Hardwareġ. I have chosen a Fujitsu-Siemens V26898-B854-V2 due to the ability to easily adapt it to the XB1X X clamp design. Is to take a stock PC heatsink with a flat bottom and adapt it to suite the XB1X. NOTE: The XB1X APU core is 9.5mm above the inside surface of the motherboard support tray where the four x-clamp stud securing holes are. Prepare the XB1X WIFI and Wireless Controller board for antenna extensionsĮxtras: (Not important so I might do later on)ĭue to the XB1X motherboard cooling setup exhausting the hot air to the front of the PC case the sock cooling setup will not work.
Prepare the XB1X WiFi and Wireless Controller board for antenna extensionsĬreate the XB1X to PC case LEDs and button wiringĬreate the APU Heatsink Mounting Hardware.Īdapt an XB1X power supply PCB to fit in a PC power supply frame.Ĭreate XB1X motherboard adapter master plate OPTIONAL CHOICES - Some required over othersĬreate XB1X motherboard adapter Master plate $20 XB1X aftermarket fan for cable + connector Not listing a lot of the items that were from my collection of electronic scrap storage like an Ethernet port from an old laptop, VRM heatsink from a PC power supply, 5.25 drive bay adapter an old disc drive, etc. Not including the cost of the XB1X or the required hardware to build a lot of the parts either but you will need to already have things like bench drills, drill bits, grinders, grinder blades, hacksaw and blades and a lathe. This mod is to develop Xbox One X and S motherboard adapter plates, hardware and wiring adapters that are able to be transplanted between different PC cases with no modification to the PC cases or Xbox motherboards.Įstimate ONLY.
0 kommentar(er)
